Adjusta-A-Wing Hellion VS3 LED Grow Lights

Adjusta-A-Wing Hellion VS3 LED Grow Lights

Adjust-A-Wings HELLION Variable Spectrum LED’s have arrived on the scene with lots of justifiable hype, demonstrating the ability of one of the world’s best horticultural lighting companies to continually raise the bar. After years of success built around the most innovative lighting reflector design, Adjust-A-Wings applied their commercial growing experience to bring out a range of tuneable LED fixtures featuring Grow, Bloom and UV diode sets - all of which can be controlled via the unit itself or through their futuristic touchscreen Master Controller. And, unlike any of the other bar LED units found in the UK right now, the four HELLION lights also use micro reflectors on each bar, showcasing that previously mentioned reflector expertise on bar LEDs for the very first time.

With Adjust-A-Wings HELLION Variable Spectrum LED Grow Lights, you'll benefit from enhanced plant control, more branching, denser flowers and off-the-chart terpenes - all while saving on power!

Enjoy A Richer Full Spectrum

All Hellion VS3 LED fixtures incorporate 3K + 5K white diodes with 660nm Reds to produce a rich baseline full spectrum. Other “full spectrum” LEDs often use just one white diode type mixed with 660nm Reds and stop there. Combining our rich base (3K + 5K + 660nm) with Far-Red and UV-A diodes delivers a superior quality light, driving increased levels of photosynthesis and promoting higher quality crops.

Master Your Grow

Hellion VS3 LEDs offer growers a revolutionary new level of photomorphogenic control. With separate dimming for veg, bloom and UV, it’s easy to dial in the perfect spectrum for compact and vigorous vegetative growth, reducing stretch during transition, and piling on weight plus colour and flavour in bloom.

Multi-Driver Efficiency

Most LED fixtures cut costs by using one single driver to run the entire fixture, inevitably compromising efficiency. The Hellion VS3 LEDs combine THREE separate drivers dedicated to veg, bloom and UV diodes, allowing new levels of system efficiency.

Deeper Canopy Penetration

Adjust-A-Wings were never going to let you down in this department! Each light bar sits beneath its own micro-reflector, helping to channel photons towards the canopy with greater precision, focus and radiant intensity. No need for efficiency-sapping lenses.

Experience “Adjust-A-Wings Plant Control” With The Efficiency Of LEDs

Iterative control over light intensity has always been at the heart of Adjust-A-Wings’ growing philosophy. By mimicking natural, seasonal cues, plants are more effectively steered indoors to harmoniously and gradually move from one lifecycle phase to another with minimal stress. This all adds up to significant increases in both yield and crop quality.

One of the most exciting features, common to all models, is the 3-channel control. Three separate drivers run VEG, BLOOM and UV diodes, meaning growers can produce stockier, more disease resistant mothers and juvenile plants, reduce stretch during transition, and increase biomass and essential oil production in flower.  

Ingenious “micro-reflectors” sit on top of each light bar helping to channel and focus the intense light without resorting to the use of inefficient lenses.

Dialing In The Perfect Spectrum

All HELLION VS3 LEDs are equipped with 3 x independent channels (VEG, BLOOM, UV) for spectral diversity and control. The VEG channel is full-spectrum, rich in Blue. BLOOM is also full-spectrum, rich in Red + Far Red, and UV provides UVA + Near Blue for a fine finish! Find your favourite mix or try our suggestions:

Propagation - gradually increase the intensity of the vegetative channel as your plants develop. Some UV can help to strengthen seedlings and cuttings. Keep the Bloom channel at the lowest setting.

Vegetative Growth - blue-dominant spectrum helps to keep plants squat and bushy, making them easier to illuminate efficiently during the bloom phase. Keep the Bloom channel at the lowest setting.

Vegetative to Bloom - combining lower bloom with higher UV and high veg can help to reduce unwanted internodal stretch. Try 20% more bloom if some stretch is desirable.

Bloom - increase bloom after the initial development of flowers. The extra Red and Far-Red promote branching and help to increase flower size and density.

Ripening/Finishing - additional UV during the final few weeks can help to boost flavours, colours and essential oils. Try leaving all channels on full and raising the fixture (5 -10cm / 2 – 4″) if ceiling height permits.

The Tech

Dimensions

250W – 540mm x 540mm x 106mm

510W – 840mm x 840mm x 106mm

700W – 1120mm x 1120mm x 106mm

1000W –1120mm x 1120mm x 106mm

Coverage Area Of Each Model 

250W – 75cm x 75cm

510W – 100cm x 100cm

700W – 120cm x 120cm

1000W – 150cm x 150cm

PPF (Photosynthetic Photon Flux – 400-700nm) Of Each Model*

250W – 620μmol/S

510W – 1325μmol/S

700W – 1850μmol/S

1000W – 2700μmol/S

PPE (Photosynthetic Photon Efficacy – 400-700nm) Of Each Model* 

250W – 2.5μmol/W

510W – 2.6μmol/W

700W – 2.6μmol/W

1000W – 2.7μmol/W

BPF (Bioactive Photon Flux – 280-800nm) Of Each Model**

250W – 650μmol/S

510W – 1375μmol/S

700W –1925μmol/S

1000W – 2800μmol/S

BPE (Bioactive Photon Efficacy)

250W – 2.6μmol/J

510W – 2.7μmol/J

700W –2.75μmol/J

1000W –2.8μmol/J

Diodes

Whites: Samsung 301H (3k + 5k)

Hyper-Red: Osram 660nm

Far-Red/IR: Osram 730nm

Near-Blue/UV: Seoul 395nm

All diodes are 50,000+ hours effective.

*Please note that these values are based on photons in the PAR range (400-700nm) and DO NOT take into account photons in both the UV-A and Far-Red regions – which are outside of the PAR range but still contribute to photosynthesis and help plants in other ways.

**BPF includes PAR+ UV/Near-Blue+ Far-Red/Near IR